New Frisco’ed Paughco tank for the Shovelhead.
Finally, the Rockers are rock’in! Last step is to check piston to valve clearance with some modeling clay.
Not yet… Three of the four strokes seem good… You are looking at rear intake roller… Needs more grinding… Good thing I pulled through by hand…
Shovelhead Cases —> Evolution Flywheels —> Evolution Pinion Shaft —> Evolution Cam —> Evolution Valve Train —> Ultima Evo Roller Rockers … (pushrods covers —> Evo bottom / Shovel top)
And a fuk load of grinding and honing!
Would I do it again?!!? NO!
Was it worth it? Only if it actually runs…
Carburetor rebuild time, S&S E “Shorty”. Damn! These things have a lot of little parts! I hope I do not have any leftover parts when I am done!!??!!
If you can’t buy it (or figure out what to buy.) Buy something close and make it work! Now I am really glad I got one of these!